联系我们
宁波铁刚精工机械科技有限公司
地址:宁波余姚市阳明街道康山村仙桥34号
电话:13858213469 18005845696
传真:0574-62267469
塑料机械
首页 > 塑料机械特点:环境友好Environmentally friendly、
制造工艺先进和选用航天航空材料Advanced manufacturing technology and selection of aerospace materials
节能50%Energy saving 50%
效率提高60%Increased efficiency by 60%
体积减少70Volume reduction of 70%
设备配置的技术参数如下表Technical Data Sheet:
型号Model 参数项目Project |
TGSK-ZW200 |
TGSK-ZW300 |
TGSK-ZW500 |
工作室容积Studio Volume(L) |
200 |
360 |
600 |
电源电压Power Supply(V-HZ) |
380-50 |
380/50 |
380/50 |
加热功率 Heating Power(KW) |
12 |
20 |
30 |
最高温度Maximum Temperature(℃) |
480 |
480 |
480 |
真空泵功率Vacuum Pump(KW) |
1.5 |
4 |
5.5 |
温控精Temperature control Accuracy(℃) |
±1 |
±1 |
±1 |
工作周期Working Period(h) |
3-5 |
3-5 |
3-5 |
工作方式Work Style |
连续continuous |
连续continuous |
连续continuous |
外型尺寸Dimensions(cm) |
130*70*116 |
145*105*116 |
195*105*205 |
重量(kg) |
550 |
950 |
1250 |
使用原理及控制.Principle of control.
1。应用塑料类高分子材料在300℃隔绝空气可裂解焦化,并产生多种裂解物,高于400℃在空气中可完全氧化的特点;把被清洗的网片加热到300℃左右,让工件表面上数量较多的塑料溶化流入到下部积料箱,自动启动真空泵接着把温度逐步升到450℃左右,并通过水喷淋洗涤器将灰尘及生成的气体抽出由水带走,按设定的工艺进入少量空气可使其充分高温氧化生成二氧化碳和灰排出.According to the plastic at 300 ℃ isolated air crackable coking, and produce a variety of lysates, higher than 400 ℃ in the air can be completely oxidized characteristics; the cleaned mesh heated to about 300 ℃, so that the surface of the mesh more Plastic melt into the accumulation box, start the vacuum pump after the temperature gradually rose to about 450 ℃, and through the water spray scrubber, the dust and the generated gas out of the water away by the set process into a small amount of air can make it Full high temperature oxidation to produce carbon dioxide and ash discharge.
2.采用温度和时间控制方式,实现参数设定下的自动控制,由精密温控制温度条件,启动泵辅工作,时间继电器控制所处理网片上不同种类塑料所需要时间(3-5小时).Using the temperature and time conditions, the parameters set automatically control.Intelligent temperature controller set to start the pump auxiliary work, time relay control takes time (3-5h).